Graymills 795-90716 LKN - Manual (Page 9)

Graymills Corporation – 3705 N. Lincoln Avenue – Chicago, IL 60613 – 773-248-6825 – Fax 773-477-8673 – www.graymills.com
CYCLE SETUP
This is the screen where the operator may set the functionality of the Liftkleen during both timed and untimed cycles.
2
1
3
4 5
Number Description
c
CYCLE TIMER – Enables or disables timed machine cycle
d MIN and SEC – By pressing the button above “MIN” and “SEC”, the operator may set the length of the timed cycle
(See Below)
e
PUMP – Enables or disables optional pump/filtration unit operation during cycle
f
OSCILLATE – Enables or disables platform oscillation during cycle
g
HOME – Returns to HOME screen
Setting Cycle Parameters
Press buttons
c
,
e
, or
f
to indicate desired cycle operation. If the operation will be performed during the cycle, the button
will display ON.
Setting a Timed Cycle
1. Press CYCLE TIMER button
c
until the button reads ON.
2. Press the MIN button and enter the number of minutes desired on the number keypad (right). Press
ENTER when finished.
3. Press the SEC button and enter the number of seconds desired on the number keypad (right). Press
ENTER when finished.
– 9