Kramer Electronics VS-162AVM - Manual (Page 15)

Configuring the VS-162AVM
11
11
Table 3: Quick Reference Operating Guide for a Single Machine
To perform this command: Press:
Set breakaway mode 1 VIDEO
Set breakaway mode 2 AUDIO
Set audio-follow-video mode 3 AFV
Connect an input with an output OUT #; IN #
Clear (disconnect) a specific output OUT #; OFF
Clear (disconnect) all outputs ALL; OFF
Connect all outputs to a specific input ALL; IN #
Store a setup
STO; OUT #; TAKE
Recall a setup RCL; OUT #; TAKE
Lock front panel MENU; TAKE
Unlock front panel TAKE; TAKE
Change default setup Press the Menu button several times until you reach the
appropriate Menu setup command and follow the instructions
7 Configuring the VS-162AVM
Using the VS-162AVM unit and/or other 16x16 matrix switchers in the
series 4
• A standalone switcher (see section
, you can assemble the following kinds of systems:
7.1 )
• A system of interconnected switchers (see section 7.2 )
Note: When configuring multiple units, each unit must have an address. For
an explanation on addressing and system modes, see section 8 .
7.1 Configuring a Standalone Switcher
By default, a single VS-162AVM unit is configured for:
• Composite video with 16 inputs and 16 outputs on BNC
connectors, and
• Balanced stereo audio with 16 inputs and 16 outputs on
detachable terminal block connectors, as shown in Figure 4 (to
configure for unbalanced 5 Figure 5 stereo audio, see and Figure 6 )
1 All operations and the LCD MATRIX display relate to the video channel (independently from audio)
2 All operations and the LCD MATRIX display relate to the audio channel (independently from video)
3 All operations and the LCD MATRIX display relate to both the video and the audio channels. Audio channels follow the
video channels
4 Including the VS-1616A (a 16x16 analog balanced stereo audio matrix switcher)
5 However, for an unbalanced stereo audio input, the output is always half of the input signal. For example, if the input is
6dB, the output is 0dB