2 recalling setups, Recalling setups – Kramer Electronics VS-162AVM User Manual

Page 37

Advertising
background image

Operating Your VS-162AVM

33

33

10.8.2 Recalling Setups

To recall a setting, do the following:

1. Press the RCL button.

The displays show the messages:

Enter SETUP number

use two digit # 01-60

RECALL

# xy

Where xy are the OUT buttons.

2. Press the appropriate two OUT buttons, using the OUTkeys # 1 to 9, and 10

(for 0). The OUTkeys function on a decimal-basis, and not on a positional-

basis. For example, to enter the # 14, press # 1 followed by # 4 (not # 14).

To enter the # 3, press # 3 followed by the TAKE button

1

.

The memory recalls the setup. The MATRIX display shows the flashing

setup, and the TAKE LED as well as the appropriate mode button

2

flashes.

The STATUS display shows the message:

RECALL

# xy

Where xy are the OUT buttons.

3. Preview the setup to decide if to implement it, by pressing the:

•

VIDEO or the AUDIO button, for video or audio setups in the

BREAKAWAY mode. Pressing the AFV button has no effect if

setups are stored in the BREAKAWAY mode

•

AFV button, for setups in the AUDIO-FOLLOW-VIDEO mode.

Pressing the VIDEO or the AUDIO button has no effect if setups

are stored in the AUDIO-FOLLOW-VIDEO mode
If you decide not to implement the setup, you can scan the other setups, by

pressing different OUT buttons. To stop previewing the setups, press a non-

relevant button, for example, an IN button.

4. Press the TAKE button.

The specific setup is implemented.

If trying to recall an empty setup

3

1 Alternatively, pressing # 10 followed by # 3 also enters the # 3

, the MATRIX display would show a

message saying that that particular setup is empty and would return you to

step 1 above.

2 VIDEO, AUDIO or AFV
3 That is, a setup # for which no setup is actually stored

Advertising