6 connecting, The vs-828 video / audio matrix switcher – Kramer Electronics VS-626 User Manual
Page 12
Connecting the VS-828 Video / Audio Matrix Switcher
9
6 Connecting
1
the VS-828 Video / Audio Matrix Switcher
To connect a single
2
VS-828 switcher, as illustrated in the example in
Figure 3, do the following
3
:
1. Connect up to 8 (6) composite video sources (for example, composite
video players) to the VIDEO INPUT BNC connectors and the AUDIO
INPUT R and L RCA connectors
4
.
2. Connect the 8 (6) VIDEO OUTPUT BNC connectors and the AUDIO
OUTPUT R and L RCA connectors
4
to up to 8 (6) composite video
acceptors (for example, composite video recorders).
3. If required, connect to a PC or other controller via RS-232 (see
section 6.2) or RS-232 and RS-485 (see section 6.3).
4. Connect the power cord to the mains electricity
4
.
5. Set the dipswitches (see section 6.1).
1 From this section on, all the information is relevant also to the VS-626, unless noted otherwise
2 Note that you can connect up to eight VS-828 units to a PC or other RS-232 or RS-485 controller
3 Switch OFF the power on each device before connecting it to your VS-828. After connecting your VS-828, switch on its
power and then switch on the power on each device
4 Not illustrated in Figure 3