Kramer Electronics VS-626 - Manual (Page 19)

Operating VS-828 Matrix Switcher
KRAMER: SIMPLE CREATIVE TECHNOLOGY
16
7 Operating VS-828 Matrix Switcher
Operate your VS-828 via:
The front panel buttons
RS-232/ RS-485 serial commands transmitted by a touch screen system,
PC or other serial controller
7.1 Displaying Unit Characteristics
The VS-828 7-segment Display shows the selected audio 1 or video 2 input
switched to the marked output
The unit characteristics
3 are displayed in the following circumstances:
Immediately (and automatically) after switching on the power; and
When simultaneously pressing and holding for 3 seconds the “IN”
buttons 1, 2 and 3
7.2 Selecting and Connecting an Output and/or Input
To select an output or input simply press the designated button on the front panel.
These buttons correspond to output connections as marked on the rear panel.
To connect a video / audio Input to a specific output, press the desired
output button, followed by the desired input button
To disconnect a video / audio Input from a specific output, press the
desired output button followed by the OFF button. To disconnect all the
outputs, press the ALL button, followed by the OFF button
To connect a video / audio Input to all outputs, press the ALL button
followed by the INPUT button corresponding to the input which is to be
routed to all the outputs
1 When the Audio button illuminates, that is, when the audio breakaway mode is selected
2 When the Video button illuminates, that is, when the video breakaway mode is selected
3 Machine model and software version