Kramer Electronics VS-66FW - Manual (Page 19)

Operating the VS-66FW
15
6.4.1 Storing an Input/Output Configuration
To store 1 the current status in memory, do the following:
1. Press the STO button.
The STO button blinks.
2. Press one of the 6 LEAF buttons (this will be the setup # in which the
current status is stored). If in the CONFIRM mode, press the blinking
TAKE button to confirm the action.
That setup # flashes brightly in the 7-segment Display and the memory
stores the data at that reference.
6.4.2 Recalling an Input/Output Configuration
To recall a configuration, do the following:
1. Press the RCL button.
The RCL button blinks.
2. Press the appropriate LEAF button (the button # corresponding to the
setup #). If in the CONFIRM mode, that setup configuration will blink in
the 7-segment Display, together with the RCL button and the TAKE button,
and will only be implemented after pressing the TAKE button.
The memory recalls the stored data from that reference.
Tip: If you cannot remember which of the 6 configurations is the one that you
want, set the VS-66FW to the CONFIRM mode and manually scan all the
configurations until you locate it.
6.5 Locking the Front Panel
To prevent changing the settings accidentally or tampering with the unit via
the front panel buttons, lock 2 your VS-66FW. Unlocking releases the
protection mechanism.
To lock the
VS-66FW:
Press and hold the LOCK button until the LOCK button is illuminated
The front panel is locked. Pressing a button will have no effect.
To unlock the VS-66FW:
Press and hold the illuminated LOCK button, until the LOCK button is no
longer illuminated
The front panel unlocks
1 Storing a new configuration over a previous configuration (without deleting it first) replaces the previous configuration
2 Nevertheless, even though the front panel is locked you can still operate via RS-232 or RS-485, as well as via the Kramer
IR Remote Control Transmitter