Kramer Electronics VS-88HCB - Manual (Page 13)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VS-88HCB
10
6 Connecting the VS-88HCB
To connect the VS-88HCB, as illustrated in the example in Figure 3, do the
following 1 :
1. Connect the video sources 2 . For example, connect:
A composite video source (for example, a video player) to the Video/Y
INPUT 1 BNC connector
An s-Video source (for example an s-Video player) to the Video/Y and
S/PDIF/C INPUT 3 BNC connectors
A component video source (for example a DVD player) to the Y,
C
B
/P
B
and C
R
/P
R
INPUT 5 BNC connectors
2. Connect up to eight 3 balanced stereo audio sources 4 to the AUDIO INPUT
terminal block connectors.
3. Connect the video acceptors. For example, connect the:
Video/Y OUT 1 BNC connector to a composite video acceptor (for
example, a composite video display)
Video/Y and S/PDIF/C OUT 3 BNC connectors to an s-Video acceptor
(for example, an s-Video display)
Y, C
B
/P
B
and C
R
/P
R
OUT 5 BNC connectors to a component video
acceptor (for example, a projector)
4. Connect the corresponding balanced stereo audio acceptors 4 to the AUDIO
OUTPUTS terminal block connectors.
5. Set the dipswitches (see section 6.5).
6. Connect a PC and/or controller (if required) to the:
RS-232 port and/or
RS-485 port and/or
ETHERNET connector
7. Connect the power cord 4 .
1 Switch off the power on each device before connecting it to your VS-88HCB. After connecting your VP-88HCB, switch on
its power and then switch on the power on each device
2 All signal connections using more than one cable to interconnect between the devices, should be of equal length
3 Alternatively, you can connect digital S/PDIF audio (when connecting component and/or composite video)
4 Not illustrated in Figure 3