Kramer Electronics WP-501 - Manual (Page 10)

Introduction
3
1.3 Trigger Types Available
Table 3 lists the types of triggers that can be used for each room controller. Section 6
Table 3: Available Triggers for Room Controllers
describes
K-Config triggers in detail.
Unit
Device
Startup
All Off / All On
(from Site-CTRL)
Device
Inactivity
Custom (from Web
page or scheduled)
Buttons
Knob
Up / Down
Scheduler
Monitor
Serial Input
GPI/O
RC-2 
RC-2C 
RC-52     
RC-52N/A     
SV-551     See note 1 See note 1  
SV-552     See note 1 See note 1  
SL-1     See note 1 See note 1   See note 4
RC-6x      
RC-6xL       
SL-14RC/N         See note 4
RC-74DL         See note 4
RC-53D  
RC-53DLC  
RC-54DL  
RC-5B2, RC-5B4 
RC-3TB/U See note 5
RC-13TC       
WP-500       
WP-501       
VP-31KSI
See note
2
See note 3
VP-81KSI
See note
2
See note 3
SL-12     See note 1 See note 1   See note 4
SL-10     See note 1 See note 1   See note 4
Note 1: This command can be available, depending on the auxiliary device connected to the Master room controller
Note 2: In the VP-81KSI, this trigger is activated when the first PC Graphics signal is detected on any one of its 8-input channels
Note 3: In the VP-81KSI, this trigger is activated when there is no active PC Graphics signal on any of its 8-input channels for a user defined
period of time
Note 4: Available only if defined as a Master room controller
Note 5: The device mimics the button triggers of
SL-14RC