Figure 12: the auxiliary device view, Figure 13: the remote control device view, Figure 14: configuration mismatch warning – Kramer Electronics WP-501 User Manual
Page 20
Defining the Control Room
13
Figure 12: The Auxiliary Device View
4. In the Control Room area, select 1 - SV-552
5. Click +.
.
6. Select a device from the list (for example, the RC-4 remote control transmitter, see
Section 4.1.2
).
The RC-4 (when selected in the Control Room area) appears in the Device View area of the
Front Panel tab).
Figure 13: The Remote Control Device View
To add additional auxiliary devices (depending on the Master RC selected, up to four Aux K-
NET devices and two Virtual Devices can be used in the same control setup, see
),
repeat the above steps
If the definition of the Control Room does not match the actual connected control room, the
following warning appears:
Figure 14: Configuration Mismatch Warning
1
It is necessary to select the Master controller to add an additional device