Kramer Electronics FC-10ETH - Manual (Page 19)

16 FC-10ETH - Controlling Machines via the Ethernet using the FC-10ETH
6. Select either:
 A virtual COM port if the control application cannot directly connect to
the Ethernet driver (see Section
5.1.1
), or

An Ethernet port connection if the control application can directly
connect to the Ethernet driver (see Section 5.1.2 )
Figure 9: Connecting the FC-10ETH in the Passive Routing Mode
5.1.1 Setting a Virtual Port
If the control application cannot work with an Ethernet driver, download the Kramer
VSPM from our Web site to set a virtual port for each local port on your FC-
10ETH.
The Kramer VSPM software lets you emulate virtual ports which normally would
be present in the machine hardware. After setup, the virtual port lets you control
Kramer machines via your PC.