Kramer Electronics FC-10ETH - Manual (Page 9)

6 FC-10ETH - Overview
# Feature Function
1 12V DC +12V DC connector for powering the unit
2 RS-232 COM 1 Port Connects to the RS-232 9-pin D-sub port on the Kramer (or
other) device 1 or PC
3 ETHERNET Port Connects to your LAN
4 RS-232 COM 2 Port Connects to the RS-232 9-pin D-sub port on a Kramer (or
other) device 2 or PC
A Kramer device can be connected to either the RS-232 COM 2
port, or to the RS-485 terminal block port (but not to both)
5 RS-485 Terminal
Block Port Connects to the RS-485 port on a Kramer (or other) device
A Kramer device can be connected to either the RS-232 COM 2
port, or to the RS-485 terminal block port (but not to both)
PIN A connects to the “A” (+) PIN; PIN B connects to the “B”
(
–) PIN (and PIN G connects to the “G (Ground)” PIN, if
necessary)
The connection to G is usually not necessary for RS-485
6 STATUS COM 1 LEDs Lit when a signal is transmitted or received from port 1
(mostly used for troubleshooting)
7 STATUS COM 2 LEDs Lit when a signal is transmitted or received from port 2
(mostly used for troubleshooting)
8 ON LED Lit when receiving power
9 RESET Button Press to reset the machine
Turns the machine off and on again while retaining its definitions
(identical to disconnecting the power adapter and then
connecting it again)
10 RS-485 TERM. Button Press for BUS termination:
Set to OFF if the RS-485 terminal block port is not connected
Set to ON if the RS-485 terminal block port is connected
11 FACTORY RESET
Button
Press to reset to factory default definitions
First disconnect the power adapter and then connect it again
while pressing the FACTORY RESET button. The unit will power
up and load its memory with the factory default definitions
12 PROG Switch Switch ON to upgrade firmware
13 CONFIG Switch Not used, set to OFF