Kramer Electronics SP-14 - Manual (Page 16)

15
Input Settings
SP-14 has many features to help improve and re-master older material.
The default settings assume that your material is good quality.
If your material is noisy or untidy at the edges or lacks definition SP-14 can be used to improve the
material in real time and at the same time as it standards converts.
The following are suggestions for correcting or improving content.
Input Adjust
[MEMC/FRC Settings ]
Time Code Settings
Input Select 3G-SDI 1
Input Adjust N/A ↓
Using the up and down arrow keys move Input Adjust to the top of the window
[Input Adjust N/A ]↑
Output Settings
Audio
Closed Captioning ↓
Each input of the Kramer processor has a dedicated memory. This allows the input characteristics to
be set for each channel without affecting either any other input or the output calibration.
The menu system is contextual therefore some filters will say NA if they are not applicable to that
input
In the main menu select Input Adjust
[Proc Amp ]
Clock Position N/A
Input Capture
Input Features ↓
The first item in this menu is the Proc Amp.
This gives access to separate colour correction of R-Y and B-Y luminance and black level cut offs, Pal
0IRE/ NTSC 7.5IRE Black level, Gamma, Hue and Saturation
The second item is for the VGA graphics input timing when scan converting from a computer.
This is normally automatic but you can make manual adjustments if your signal requires this
The third item is Input Capture
[Overscan 0.0%]
Input Window Shift Horz 2048
Input Window Shift Vert 0