Kramer Electronics TP-46 User Manual
Page 12
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting a Component/XGA – Audio Distribution System
10
5
Connecting a Component/XGA – Audio Distribution
System
The Component/XGA – Audio Distribution System can be configured to
operate in one of two video modes:
• In the XGA mode, a computer graphics source is connected to the input
and transmitted to a display connected to the receiver (see section
)
• In the component video mode, a component video source is connected
to the input and transmitted to a TV set connected to the receiver (see
section
)
The Component/XGA – Audio Distribution System can be configured to
operate in one of two audio modes:
• In the analog mode, an analog audio source is connected to the input
and transmitted to an acceptor connected to the receiver (see section
)
• In the digital audio mode, an S/PDIF audio source is connected to the
input and transmitted to a digital acceptor connected to the receiver
(see section
Thus, there are four possible system configurations: computer
graphics/analog audio, computer graphics/digital audio, component
video/analog audio, and component video/digital audio.
The modes of the system are determined by setting the VIDEO SELECT
and AUDIO SELECT switches on the TP-45 or TP-45RC. Whatever
modes are set at the transmitter the video and audio signals are sent to the
receiver and any additional cascaded receivers
.
1 There is no signal conversion; a component input cannot be sent to a computer graphics output, nor can a digital audio input
be sent to an analog audio output