Kramer Electronics TP-46 - Manual (Page 6)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Overview
4
• Digital audio input (S/PDIF) on an RCA connector and a stereo
analog input on a 3.5mm mini jack
• The Power Connect feature where one unit can power the other over
the same twisted pair cable (see section 3.1 )
• 12V DC power
The TP-45RC Component/UXGA – Audio Transmitter features the same
functions as the TP-45 with the addition of:
• Toggling push-button selector switches and status LEDs connected by
a remote selector input terminal block
The TP-46 Component/XGA – Audio Receiver features:
• YUV 5 output on 3 RCA connectors and a computer graphics output on
a 15-pin HD (F) connector
• Digital audio output (S/PDIF) on an RCA connector and a stereo
analog output on a 3.5mm mini jack
• The Power Connect feature where one unit can power the other over
the same twisted pair cable (see section 3.1 )
• H and V Sync polarity switches for computer graphics
• EQ. and LEVEL controls
• A twisted pair output for transmitting the signal to an additional
receiver
• 12V DC power
3.1 About the Power Connect Feature
The Power Connect feature applies as long as the cable can carry power.
This feature is available when using STP cable and the distance does not
exceed 50m on standard twisted pair cable. For longer distances, heavy
gauge cable should be used
1 . For units which are connected via RJ-45
connectors, make sure that the shield of the STP cable is connected to the
metal casing of the connectors on both ends of the cable. For units which
are connected via terminal block connectors, the shield of the STP cable
must be connected to a ground terminal on the units at both ends (use the
ground terminal of the power supply connection if necessary).
For a twisted pair cable exceeding a distance of 50m, separate power
supplies should be connected to the transmitter and to the receiver
simultaneously.
1 CAT 5 cable is still suitable for the video/audio transmission, but not for feeding the power at these distances