DuraVent PolyPro Flex - Manual (Page 8)

8
Figure 8, Required Liner Length
1
B
Figure 7, Mounting the Wall Plate
A
=
=
=
=
1
Figure 9, Installing Vent Cap
1
2
3
Figure 10, Installing Termination Pieces
1
2
13. Fit the Support Bracket (see 1, Fig.8)
over the liner and let it rest on the wall of the
shaft. Mount the Gasket as detailed above
(see Fig.1). Push the Flex Female Adapter on
the liner and close the latching tabs. Allow
the assembly to rest on the Support Bracket.
14. Seal the edge of the chimney shaft with
water-resistant sealant (see 1, Fig.9) and push
the Flex Chimney Flashing (see 2, Fig.9) on
the shaft and fix it with four masonry anchors
(see 3, Fig.9).
15. Install the Termination Pipe(see 1 ,
Fig.10). Assemble the storm collar portion of
the Flex Chimney Flashing (see 2, Fig.10).
16. Connect the appliance to the flexible vent
system with M&G DuraVent rigid PolyPro vent
system.