Sunlight Supply Titan Controls® Helios® 8 - 8 Light 240V Controller with Dual Trigger Cords User Manual
Helios 8, Easy guide, Instructions for use
Instructions for Use
1. Please consult with a licensed electrician prior to installation
of the Helios 8. High voltage can be dangerous!
2. Connect 240 volt power to the 3 screws under the protective
cover. (See ‘Instructions for Operation’ section).
3. Replace protective cover with screws provided.
4. Securely mount your Helios 8, with hardware provided, near
the ballasts to be operated. It should be placed away from
water, mist, spray, etc.
5. Plug your 240 volt ballasts into the multi-tap outlets on the
left and right side of the controller.
6. Plug the relay activation cord set into Apollo Series wall timer.
7. Your Helios 8 will now control your ballasts at the desired
settings until the power is defeated.
Helios 8
TM
8 Light - 240 Volt Lighting Controller
Easy Guide
VANCOUVER, W ASHINGTON U.S.A.
®
Easy Guide
Controller Specifi cations
Size: 13"H x 11"W x 4"D
Weight: 10 lbs.
Voltage Input: 240 volts
Voltage Output: 240 volts
Maximum Amperage: 40 amps
Maximum Wattage: 8000 Watts
Hertz: 60 Hz
Time Switch: Two(2)120 Volt relay trigger cord sets
Operating Temperature: 40
° to 125° F | 5° to 52° C
Storage Temperature: 32
° to 135° F | 0° to 57° C
to 50 Amp
Power Source
to 240 Volt Ballast
to 240 Volt Ballast
Helios 8
240 Volt
Sun System
R
Sun System
R
to 240 Volt Ballast
to 240 Volt Ballast
to 240 Volt Ballast
to 240 Volt Ballast
to 240 Volt Ballast
Sun System
R
to 240 Volt Ballast
Sun System
R
Sun System
R
Sun System
R
Sun System
R
Sun System
R
120 Volt
to 120 Volt
Timer
Titan Apollo
24 HR
Timer
120 Volt
Titan Apollo
24 HR
Timer
Wiring
diagram
Hot
Neutral
Hot
Ground
Controlling a light bank
®
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.