Sunlight Supply Titan Controls® Mercury® 2 - Fan Speed Controller - Manual

Mercury 2
Fan Speed Controller
Easy Guide
VANCOUVER, WASHINGTON U.S.A.
®
® www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
Step 1
Plug fan into 120 Volt outlet
on the front of the Mercury 2.
Step 2
Set your preferred fan setting
on the Mercury 2.
OptiOnal SettingS
inStRUCtiOnS – Rev. a
“Fire-Up” Feature
The customer can easily enable or disable the “Fire-Up” feature by following
the instructions below. The “Fire-Up” feature will active your fan at 100%
for 2 seconds and then reduce the speed to match your preferred setting
whenever your fan is activated for the first time or you experience a power
outage. This improves the start up of your fan and extends the life of your
fan. It is recommended that you enable the ‘Fire-Up’ feature if you set your
Mercury 2 at slow speeds. The default setting from the factory enables the
“Fire-Up” feature.
Note: This unit has been set to perform in the
“Fire-Up” position from the factory.
100%
OFF
10%
50%
100%
OFF
10%
50%
100%
OFF
10%
50%
Step 3
Plug the Mercury 2 into single phase 120 Volt wall outlet
and fan should be activated at your preferred setting.
installation is now complete.
The “Fire-up” feature can be activated by the customer by:
• Unplugging the Mercury 2 and setting the knob to “100%”.
(Diagram 2)
• Then plug the Mercury 2 into your 120 volt outlet, turn to 10%
and then turn to 100% within three (3) seconds. (Diagram 3)
• To verify the setting, plug your fan into the Mercury 2, then
unplug the Mercury 2 and plug back in to see (or hear) the effect
of the “Fire-Up” feature in action
DIAGRAM 1 DIAGRAM 2 DIAGRAM 3
100%
OFF
10%
50%
DIAGRAM 2
100%
100%
OFF
10%
50%
DIAGRAM 3