WIKA O-10 - Manual (Page 6)

6 WIKA operating instructions pressure transmitter model O-10
GB
11613017.04 05/2013 GB/D/F/E
2. Safety
2. Safety
WARNING!
Before installation, commissioning and operation, ensure that the appropriate pressure
transmitter has been selected in terms of measuring range, design and specific measuring
conditions.
Non-observance can result in serious injury and/or damage to the equipment.
WARNING!
■ Open the connections only after the system has been depressurised.
■ Observe the working conditions in accordance with chapter 3 "Specifications".
■ Always operate the pressure transmitter within the overpressure safety range.
Further important safety instructions can be found in the individual chapters of these
operating instructions.
2.1 Intended use
The pressure transmitter is used to convert pressure into an electrical signal.
Model O-10 (T): Standard version
Model O-10 (5): With 5-fold overpressure limit and condensation-tight case.
For applications with water as a medium a 5-fold overpressure safety for protection
against water hammer effects and a condensation-tight case is recommended.
The instrument has been designed and built solely for the intended use described here, and may only
be used accordingly.
The technical specifications contained in these operating instructions must be observed. Improper
handling or operation of the instrument outside of its technical specifications requires the instrument to
be taken out of service immediately and inspected by an authorised WIKA service engineer.
The manufacturer shall not be liable for claims of any type based on operation contrary to the intended
use.