Asante Technologies 8000 - Manual (Page 154)

Web Browser Management
Page 5-14
VLAN Button
This button opens the VLAN Groups page, as shown in Figure 5-12. The
page shows the modules of the IntraCore 8000, and the ports that are
assigned to the currently selected VLAN. There is also a panel that shows
the VID of each VLAN on the current switch; to select a VLAN, click the
appropriate VID. For information about VLANs, see Chapter 4.
Figure 5-12 VLAN Groups page
To configure the selected VLAN, click the VLAN button. To configure the
ports for the selected VLAN, click the Ports button.
Port Configuration
Clicking the Ports button in the VLAN Groups page opens the VLAN Port
Selection page, as shown in Figure 5-13. The page shows the modules of the
IntraCore 8000. There is also a panel indicating the current Port VLAN ID
and its settings.
To see and modify the settings for a port, click on the connector for it in the
module simulation. Then make the appropriate settings in the right-hand
panel of the page.