Cirrus Logic CS4391 - Manual (Page 32)

CS4391
32 DS335PP4
7. APPLICATIONS
7.1 Recommended Power-up Sequence
for Hardware Mode
1) Hold RST low until the power supplies, master,
and left/right clocks are stable.
2) Bring RST high.
7.2 Recommended Power-up Sequence
and Access to Control Port Mode
1) Hold RST low until the power supply, master,
and left/right clocks are stable. In this state, the
control port is reset to its default settings and
CMOUT will remain low.
2) Bring RST high. The device will remain in a
low power state with CMOUT low and the con-
trol port is accessible.
3) Write 11h to register 5 within 10 ms cycles fol-
lowing the release of RST.
4) The desired register settings can be loaded
while keeping the PDN bit set to 1.
5) Set the PDN bit to 0 which will initiate the pow-
er-up sequence which requires approximately
10 µS.
7.3 Analog Output and Filtering
The application note “Design Notes for a 2-Pole
Filter with Differential Input” discusses the sec-
ond-order Butterworth filter and differential to sin-
gle-ended converter which was implemented on the
CS4391 evaluation board, CDB4391. The CS4391
filter, as seen in Figure 14, is a linear phase design
and does not include phase or amplitude compensa-
tion for an external filter. Therefore, the DAC sys-
tem phase and amplitude response will be
dependent on the external analog circuitry.
AMUTEC
AOUTA+
GND
C43
10UF
GND
GND
GND
1.18K R17
NC 4
3
2
1
CON_RCA_RA
J3
2
3
1
2SC2878
Q1
2K R25
3
1
2
Q3
MMUN2111LT1
12 HDR8
HDR1X2
AOUTA
VA+3/+5
R20 560
3
1
2
Q4
MMUN2211LT1
R24 5.62K
R5
47K
R28 5.62K
1.18K R18
5.62K
R15
5.62K R26
C49
.1UF
V-
V+
+
-
4
8
1
2
3
U11
MC33078D
C48
.1UF
GND
GND
GND GND
GND
GND
C42
10UF
COG
2700PF
C7
COG
560PF C6
COG
C5
560PF
COG
2700PF
C14
VCC
VEE
AOUTA-
Figure 15. CS4391 Output Filter