Acer 500L - Manual (Page 71)

Chapter 3 BIOS Utility 3-25
Num Lock After Boot
This parameter allows you to activate the Num Lock function upon
booting. The default setting is
Enabled .
Memory Test
When set to Enabled , this parameter allows the system to perform a
RAM test during the POST routine. When set to Disabled , the
system detects only the memory size and bypasses the test routine.
The default setting is
Enabled.
Configuration Table
This parameter allows you to enable or disable the appearance of the
configuration table after POST but before booting. The configuration
table gives a summary of the hardware devices and settings that BIOS
detected during POST.
Boot from LANDesk Service Agent
When set to Enabled , the system boots from a LANDesk Service
Agent network instead of your desktop system. The LANDesk Service
Agent is IEEE-standards-based code that intervenes in the boot
process. Please refer to your LANDesk Manual for more information.
When set to Disabled , the system boots from the drive specified in
the Boot Sequence parameter.