Cirrus Logic CS5345 - Manual (Page 35)

DS658F4 35
CS5345
6.7 Channel A PGA Control - Address 08h
6.7.1 Channel A PGA Gain (Bits 5:0)
Function:
Sets the gain or attenuation for the ADC input PGA stage. The gain may be adjusted from -12 dB to
+12 dB in 0.5 dB steps. The gain bits are in two’s complement with the Gain0 bit set for a 0.5 dB step.
Register settings outside of the ±12 dB range are reserved and must not be used. See
Table 11 for ex-
ample settings.
6.8 ADC Input Control - Address 09h
6.8.1 PGA Soft Ramp or Zero Cross Enable (Bits 4:3)
Function:
Soft Ramp Enable
Soft Ramp allows level changes, both muting and attenuation, to be implemented by incrementally ramp-
ing, in 1/8 dB steps, from the current level to the new level at a rate of 1 dB per 8 left/right clock periods.
See
Table 12 .
Zero Cross Enable
Zero Cross Enable dictates that signal-level changes, either by attenuation changes or muting, will occur
on a signal zero crossing to minimize audible artifacts. The requested level change will occur after a time-
out period between 512 and 1024 sample periods (10.7 ms to 21.3 ms at 48 kHz sample rate) if the signal
does not encounter a zero crossing. The zero cross function is independently monitored and implemented
for each channel. See
Table 12 .
Soft Ramp and Zero Cross Enable
Soft Ramp and Zero Cross Enable dictate that signal-level changes, either by attenuation changes or mut-
ing, will occur in 1/8 dB steps and be implemented on a signal zero crossing. The 1/8 dB level change will
occur after a time-out period between 512 and 1024 sample periods (10.7 ms to 21.3 ms at 48 kHz sam-
ple rate) if the signal does not encounter a zero crossing. The zero cross function is independently mon-
itored and implemented for each channel. See
Table 12 .
7 6 5 4 3 2 1 0
Reserved Reserved Gain5 Gain4 Gain3 Gain2 Gain1 Gain0
Gain[5:0] Setting
101000 -12 dB
000000 0 dB
011000 +12 dB
Table 11. Example Gain and Attenuation Settings
7 6 5 4 3 2 1 0
Reserved Reserved Reserved PGASoft PGAZero Sel2 Sel1 Sel0