Cirrus Logic CS5351 - Manual (Page 14)

14 DS565F2
CS5351
2. PIN DESCRIPTIONS
Pin Name # Pin Description
RST 1 Reset (Input) - The device enters a low power mode when low.
M/S 2 Master/Slave Mode (Input) - Selects operation as either clock master or slave.
LRCK
3 Left Right Clock (Input/Output) - Determines which channel, Left or Right, is currently active on the
serial audio data line.
SCLK 4 Serial Clock (Input/Output) - Serial clock for the serial audio interface.
MCLK 5 Master Clock (Input) - Clock source for the delta-sigma modulator and digital filters.
VD 6 Digital Power (Input) - Positive power supply for the digital section.
GND
7
18
Ground (Input) - Ground reference. Must be connected to analog ground.
VL 8 Logic Power (Input) - Positive power for the digital input/output.
SDOUT 9 Serial Audio Data Output (Output) - Output for two’s complement serial audio data.
MDIV 10 MCLK Divider (Input) - Enables a master clock divide by two function.
HPF 11 High Pass Filter Enable (Input) - Enables the Digital High-Pass Filter.
I²S/LJ 12 Serial Audio Interface Format Select (Input) -Selects either the Left-Justified or I²S format for the SAI.
M0
M1 13
14
Mode Selection (Input) - Determines the operational mode of the device.
OVFL 15 Overflow (Output, open drain) - Detects an overflow condition on both left and right channels.
AINL
AINR 16
21 Analog Inputs (Input) - The full-scale analog input level is specified in the Analog Characteristics speci-
fication table.
VQ1
VQ2
VQ3 17
20
22
Quiescent Voltage (Output) - Filter connection for the internal quiescent reference voltage.
VA 19 Analog Power (Input) - Positive power supply for the analog section.
REF_GND 23 Reference Ground (Input) - Ground reference for the internal sampling circuits.
FILT+ 24 Positive Voltage Reference (Output) - Positive reference voltage for the internal sampling circuits.
RST 1 24 FILT+
M/S 2 23 REFGND
LRCK 3 22 VQ3
SCLK 4 21 AINR
MCLK 5 20 VQ2
VD 6 19 VA
GND 7 18 GND
VL 8 17 VQ1
SDOUT 9 16 AINL
MDIV 10 15 OVFL
HPF 11 14 M1
I²S/LJ 12 13 M0