8 external connector, 4 power supplies, 1 analog voltage regulators – Cirrus Logic CDB5374 User Manual

Page 30: Cdb5374

Advertising
background image

CDB5374

30

DS862DB1

2.3.8

External Connector

Power supplies and telemetry signals route to a 20-pin double row connector with 0.1" spacing (J26). This
header provides a compact standardized connection to the CDB5374 external signals.

2.4

Power Supplies

Power is supplied to CDB5374 through banana jacks (J6, J7, J8, J9) or through the external connector
(J26). The banana jacks make separate connections to the EXT_VA-, EXT_VA+, GND, and EXT_VD
power supply nets, which connect to the analog and digital linear voltage regulator inputs. The external
connector makes separate connections only to the EXT_VA-, GND, and EXT_VA+ power supply inputs
and it is required to jumper EXT_VA+ to EXT_VD when powering CDB5374 from the external connector.

The EXT_VA-, EXT_VA+ and EXT_VD power supply inputs have zener protection diodes that limit the
maximum input voltages to +13 V or -13 V with respect to ground. Each input also has 100 uF bulk ca-
pacitance for bypassing and to help settle transients and another 0.01 uF capacitor to bypass high-fre-
quency noise.

2.4.1

Analog Voltage Regulators

Linear voltage regulators create the positive and negative analog power supply voltages to the analog
components on CDB5374. These regulate the EXT_VA+ and EXT_VA- power supply inputs to create the
VA+ and VA- analog power supplies.

Pins Name

Signal

1, 2

CLK+, CLK-

Clock Input

3, 4

SYNC+, SYNC-

Synchronization Input

5, 6

SCL+, SCL-

I2C Clock

7, 8

SDA+, SDA-

I2C Data

9, 10

BYP_SDA+, BYP_SDA-

I2C Data Bypass

11, 12

BYP_SCL+, BYP_SCL-

I2C Clock Bypass

13, 14

TX, GND

UART transmit

15, 16

RX, GND

UART receive

17, 18

EXT_VA-, GND

Negative Power Supply

19, 20

EXT_VA+, GND

Positive Power Supply

Specification Value
Positive Analog Power Supply

+2.5 V, +5 V

Low Noise Micropower Regulator - Linear Tech

LT1763CS8

Surface Mount Package Type

SO-8

Load Regulation, -40 C to +85 C

+/- 25 mV

Quiescent Current, Current @ 100 mA Load

40

µA, 2 mA

Output Voltage Noise, 10 Hz - 100 kHz

20

µV

RMS

Ripple Rejection, DC - 200 Hz

> 50 dB

Advertising