Alliance Laundry Systems H264I - Manual (Page 12)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
801480 10
Meter Case
The factory mounted coin meter case does not include
the service door lock, slide, coin drawer, coin drawer
lock or keys. These parts must be ordered (at extra
cost) according to the purchaser’s requirements, direct
from the manufacturer of your choice.
NOTE: You have the option of using a screw type
lock or a 1/4 turn lock on the meter case service
door. If you choose to use a screw lock, then the
special bracket (located inside the meter case) must
be used. DO NOT use the special bracket if a
1/4 turn lock is used.
Coin Drawer Security – For additional security, drill
out the two pilot holes on each front side of the meter
case to 1/4 turn or 5/16 inch (6.4 or 7.9 mm) holes, and
install a bicycle lock through these holes.
Before You Start
Tools
For most installations, the basic tools you will need
are:
Figure 1
Electrical
Refer to serial plate for specific electrical
requirements. For more detailed information, refer to
section on Electrical Requirements.
Water
Washer needs two standard 3/4 inch (19.1 mm) water
supply faucets with a pressure between 20 and
120 pounds per square inch (138 to 827 kPa). For
more detailed information refer to section on Water
Supply Requirements.
D820I
1 Wrench
2 Screwdriver
3 Pliers
4 Socket Wrench
5 Level
1
2 3
5
4