Alliance Laundry Systems H264I - Manual (Page 25)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
23 801480
Indicator Lights
IN USE
This light will remain on while washer is in use.
DOOR LOCKED
This light will come on after the PUSH-TO-START
button has been pressed and the washer door has
locked. It will remain on until the wash cycle has
ended.
FINAL SPIN AND TUMBLE
This light will come on at the start of the final spin and
remain on until the wash cycle has ended.
CLOSE DOOR
This light will come on if door is not closed tightly.
Firmly push door until light goes out.
IMPORTANT: If washer fails to operate properly
after installation, make sure electrical service and
water supply faucets are turned on. Are all the
controls properly set? Have a qualified service
person refer to the wiring diagram (located inside
of cabinet) and check for broken, loose or incorrect
wiring.
NOTE: Once a cycle has started, the door can only
be opened by first unplugging the power cord and
waiting one minute.
The washer will stop (pause) shortly before the first
spin and final spin.
Rapid Advance
The Rapid Advance feature allows the owner to
quickly advance through an active cycle to a specific
cycle step.
To enter Rapid Advance, open the service door long
enough for the IN USE light to turn on and close the
door. Refer to Figure 22.
NOTE: If service door remains open, rapid cycles
will be a free vend.
Press the PUSH-TO-START button to start the cycle.
Press PUSH-TO-START button again to advance
through each cycle step. Refer to Table 1 for cycle
steps.
To reduce the risk of bodily injury, do not
remove laundry from washer until all
lights are out, and all moving parts have
stopped.
W092
WARNING
Cycle Steps
Wash Fill/Agitate cycle step
Wash Distribute cycle step
Wash Pulse Spin cycle step
Rinse Fill/Agitate cycle step
Rinse Distribute cycle step
Rinse Pulse Spin cycle step
Extra Rinse Fill/Agitate cycle step (If extra rinse is
enabled)
Extra Rinse Distribute cycle step (If extra rinse is enabled)
Extra Rinse Pulse Spin cycle step (If extra rinse is enabled)
Final Fill/Agitate cycle step
Final Distribute cycle step
Final Pulse Spin cycle step
Final High Spin cycle step (Final Spin light on)
Breakaway cycle step (Final Spin light on)
End of cycle (door will remain locked for about 1 minute)
Table 1