EasyN F Series User manual - Manual (Page 18)

English EasyN IP Camera User Manual
www.easyn.com MFE-E-A3
17
sender email address is [email protected], enter ‘mail.163.com’. In general, SMTP port is
25. If the SMTP port need authentication, check the box and enter SMTP user name
and SMTP password, which are provided by Email provider, and then test. Please
check Report Internet IP by Mail if you want to provide the Internet IP in the email
being sent. The e-mail server and other information can be obtained from the mail
service provider. The email notifications are pictures captured by camera when alarm
is on. You don’t have to enter all these information if you prefer to be notified through
email when the alarm is on.
3.4.11. FTP Service Settings
The above settings are similar to those of the Mail service Settings.
Please enter FTP server, FTP port, FTP user, FTP password, FTP upload directory
and FTP mode. The FTP mode has two options: PORT and POSV. If a quick
upload picture is need , select Upload Image Now and change its interval（second）。
3.4.12. Alarm Service Settings
As shown below, there are two modes of alarm trigger. One of them is motion
detection (please refer to the interface below). The sensitivity of motion detection can
be adjusted according to the requirement of the user, the higher the number is, and the
lower the sensitivity is. Another alarm trigger is input alarm, when connected, it
triggers alarm through alarm input signal which is linked to the alarm GPIO;
When triggered, there are 3 alarm modes: 1) IO alarm linkage, camera connects
with linked alarm box through GPIO, sound the siren ；2) email notification which
sends email with images captured；3) upload pictures alarm，as the way mentioned
before FTP upload pictures alarm, Upload pictures interval（second）keeps consistent
with the mentioned upload pictures interval of Ftp service settings.
The schedule refers to the arming time: