FMI SCST-01 - Manual

http://www.fmipump.com
"SCST-01" STEP MOTOR
CONTROL KIT
OPERATION INSTRUCTIONS
IN-SCST-01-10 1
New FMI Step Motor Control Kit “SCST-01”
Congratulations! Your FMI Step Motor Control Kit SCST-01 is a complete control
package designed specifically for FMI pumps with step motors. It’s small in size but big
in performance and provides a quick method to run your pump today.
Quick Start Instructions
Your controller is initially set to provide 320 strokes/minute or 150 strokes/minute.
Dispense and other speed settings are easily set by following the detailed instructions
on the following pages.
1. Connect harness J1 & J2 to appropriate connectors on board. The black and white
wires from J1 connect to the power supply. White (or black with white lettering) is the
positive lead while solid black is negative.
*Connect DIP Switch Assembly to Header J3 (Pin 1 to red stripe)
DO NOT TURN POWER ON
2. Connect motor wires to terminal block J1 according to the following chart:
Table1.
Motor Lead Color for Standard
STRH/STH/STQ/SQ pumps
STRH/STH/STQ/SQ
Duplex
Screw Terminal
Color
Motor Phase Motor P/N 110746
(NEMA 23 Frame) Motor P/N 110745
(NEMA 17 Frame) Motor P/N 300615
(NEMA 23Frame)
Yellow A Yellow and Black Yellow Orange & White w/Black
Stripe
Red A Red and White Red Black & White w/Orange
Stripe
Brown B Blue and Orange Orange Yellow & White w/Red Stripe
Orange B Green and Brown Blue Red & White w/Yellow
Stripe
3. Connect pump sensor leads to J2 according to color i.e. Red to Red, etc.
4. Turn on power and pump will start running at factory setting. Note: See 4.1 page 6.
*Basic Boards use jumper pin connector shunts instead of DIP switch.
1.0 Description