FMI CL1 - Manual

OVERVIEW:
Congratulations.
Your Chloritrol ®
CL System
from
Fluid Metering Inc. is the newest patented innovation
in 50 years for accurate, low maintenance injection of
sodium hypochlorite for water and wastewater
treatment. FMI’s CL, along with it’s CTS Chemical
Treatment System for caustic soda, are the easiest
chemical feed systems for water and waste treatment
in the world.
The patented Chloritrol ® CL & CTS systems eliminate
check valves and/or peristaltic tubing typically present
in traditional hypochlorite metering systems, which are
the primary sources of downtime and frequent
maintenance . The CL & CTS Systems will never lose
prime, even against pressure, or air lock. The
Chloritrol ® CL system consists of the CL Pump
Module
and C100A Variable Speed Controller.
The CL Pump Module is a unique valveless duplex
FMI CeramPump® and an FMI RO “sipper” pump
direct coupled to a single variable speed drive motor.
The high-pressure CeramPump ® injects the
hypochlorite directly into the main water stream, while
the RO “sipper” pump removes any gas generated
because of chlorine out-gassing, eliminating “gas lock”
and/or loss of prime.
CHLORITROL
®
CL with C100A
Liquid Hypochlorite Injection System
INSTALLATION & OPERATING INSTRUCTIONS
IN-CL-14
3/11/14 HW
The C100A Variable Speed Controller from Fluid
Metering, Inc. is specifically designed to interface
with the Chloritrol ®
CL Pump Module.
This
controller provides a variable 0-90 VDC power
source, which is controlled either manually using a
panel mounted rotary dial, or electronically via a
4-20 mA control input.*
* Other commercially available controllers may work, however we
recommend contacting FMI for details.
Page 1 of 10
Chloritrol ® CL Pump Module
and C100A Variable Speed Controller