FMI Q647 - Manual

The FMI Mounting Base Kit Q647 allows horizontal or vertical mounting of "Q" line pumps. It replaces the
Multi-Position Tilt Stand Q650 that is standard on most models.
1.0 Read Safety Instructions carefully before attempting to install Q647 Mounting Base Kit.
2.0 Remove Q650 Multi-Position Tilt Stand from base assembly by loosening the two mounting screws
washers, weld nuts, cross bar and protective caps.
3.0 Remove the two rubber feet and drive screws from base assembly.
4.0 Reverse the stroke adjustment assembly *Remove speed knob from the assembly (Not required),
and add Q447 Flow Control Bushing (Refer to Fig 1 ).
5.0 Install Mounting Base Q648 by positioning the Mounting Base under the assembly and lining up the
mounting holes. Secure using self tapping screws 110528-6 in the front and Socket Head Screws
110290-12, Lock Washers 110049 and Hex Nuts 110133 in rear (Refer to Fig 1).
6.0 See Figure 2 for Mounting Base Q647 Bolt Hole Pattern.
Q647 MOUNTING BASE KIT
(PLEASE REFER TO DRAWINGS ON REVERSE SIDE OF THIS SHEET)
Assembly Instructions Q647 Mounting Base Kit
Fig 1
QTY PART NO.
PARTS LIST
DESCRIPTION ITEM
1 110049 WASHER, INT. TOOTH LOCK #8 4
2 110133 NUT, HEX 8-32 X 11/32" 2
3 110290-12 SCREW, SHC 8-32 X 3/4" 2
4 110528-6 SCREW, PHS 8-32 X 3/8" SELF TAP 2
5 Q447 FLOW CONRTOL BUSHING 1
6 Q648 PEDESTAL BRACKET, QP 1
®
CERAMPUMP
www.fmipump.com
1
1
1
2
3
4
4
5
(2X)
(2X)
(2X)
1/4-20 LOCK NUT
1/4" FLAT WASHER
FOLLOWER
KNOB ASSEMBLY
FLOW CONTROL
BUSHINGS
6
HEX NUT
(SNUG UP)
Fig 2
IN-Q647 / 09