KMW Communications AICM - Manual (Page 5)

Sheet 5 of 17 Sheet 5 of 17 05-30-2006
CONFIDENTIAL
AICM 1: 1
Interface Program
AICM
Message
Request Control, Status
Response Control, Status
Time Over
ACK
NACK
Retry # 1
Retry # 2
Retry
Communication Fail
Time Over
Time Over
NACK
NACK
Retry
<Figure 1-2> Requests and Responses of the program
2. System requirements (minimum)
OS: Windows 2000, Windows XP
PENTIUM 4: 700MHz
RAM: 256MB
Display: 1024 * 768 pixel
3. Communication Protocol
TCP/IP Protocol : This is not available for the 1:1 interface program.
RS-232C Protocol(Baud rate: 38400bps, Data bit: 8bit, Parity bit: None, Stop bit: 1bit)
4. Installation and Getting started with the program
A user runs a setup file (NewAicm[1.69].exe) after choosing a destination folder. A shortcut of the program is
generated at the desktop screen upon completion. A program is installed successfully when the user follows the steps
below Figure 4-1 to Figure 4-5. Next, the program will run when the user clicks a Start button on Windows taskbar->
Programs-> Air Interface Control & Monitoring program group -> NewAicm.( Refer to Figure 4-6.)
Copyright © 2006 KMW Inc., All Rights Reserved