MSI RS480M2 - Manual (Page 38)

3-7
BIOS Setup
items. Enter the information directly from the keyboard. This information should be
provided in the documentation from your hard disk vendor or the system manufacturer.
[Access Mode] The settings are [CHS], [LBA], [Large], [Auto].
[Capacity] The formatted size of the storage device.
[Cylinder] Number of cylinders.
[Head] Number of heads.
[Precomp] W rite precompensation.
[Landing Zone] Cylinder location of the landing zone.
[Sector] Number of sectors.
Drive A
This item allows you to set the type of floppy drives installed. Available options:
[None], [360K, 5.25 in.], [1.2M, 5.25 in.], [720K, 3.5 in.], [1.44M, 3.5 in.], [2.88M, 3.5 in.].
Video
The setting controls the type of video adapter used for the primary monitor of the
system. Available options are [EGA/VGA], [CGA 40], [CGA 80], and [Mono].
Halt On
The setting determines whether the system will stop if an error is detected at boot.
Available options are:
[All Errors] The system stops when any error is detected.
[No Errors] The system doesn ’t stop for any detected error.
[All, But Keyboard] The system doesn ’t stop for a keyboard error.
[All, But Diskette] The system doesn ’t stop for a disk error.
[All, But Disk/Key] The system doesn ’t stop for either a disk or a key-
board error.
Base/Extended/Total Memory
The three items show the memory status of your system (read only).