MSI RS480M2 - Manual (Page 47)

3-16
MS-7093 M-ATX Mainboard
Super IO Device
Press <Enter> to enter the sub-menu and the following screen appears:
Onboard FDC Controller
Select [Enabled] if your system has a floppy disk controller (FDD) installed on
the system board and you wish to use it. If you install add-on FDC or the system
has no floppy drive, select [Disabled] in this field. The settings are: [Enabled]
and [Disabled].
Onboard Serial Port 1
Select an address and corresponding interrupt for Serial Port 1. The settings
are: [3F8/IRQ4], [2E8/IRQ3], [3E8/IRQ4], [2F8/IRQ3], [Disabled], [Auto].
Onboard Parallel Port
This specifies the I/O port address and IRQ of the onboard parallel port. Settings:
[378/IRQ7], [278/IRQ5], [3BC/IRQ7], [Disabled].
Parallel Port M ode
This setting specifies the parallel port mode.
SPP: Standard Parallel Port
EPP: Enhanced Parallel Port
ECP: Extended Capability Port
Setting options: [SPP], [EPP1.9+SPP], [ECP], [EPP1.9+ECP], [EPP1.7+SPP], [EPP1.
7+ECP].
ECP Mode Use DMA
The ECP mode has to use the DMA channel, so choose the onboard parallel port
with the ECP feature. After selecting it, the following message will appear:
“ECP
Mode Use DMA. ” At this time, the user can choose between DMA channel [3] or
[1].