MSI Keeper 945GME V2.1 - Manual (Page 25)

2-13
Hardware Setup
Fan Power Connectors: CPUFAN0, SYSFAN1, AUXFAN0
The fan power connectors support system cooling fan with +12V. W hen connecting
the wire to the connectors, always note that the red wire is the positive and should
be connected to the +12V, the black wire is Ground and should be connected to GND.
If the mainboard has a System Hardware Monitor chipset on-board, you must use a
specially designed fan with speed sensor to take advantage of the CPU fan control.
Important
Please refer to the recommended CPU fans at Intel ® official website or
consult the vendors for proper CPU cooling fan.
PIN SIGNAL DESCRIPTION
1 HD_LED + Hard disk LED +
2 FP PWR/SLP Power LED +
3 HD_LED - Hard disk active LED
4 FP PWR/SLP Suspend LED +
5 RST_SW - Reset Switch -
6 PWR_SW + Power Switch +
7 RST_SW + Reset Switch +
8 PWR_SW - Power Switch -
9 RSVD_DNU Reserved.
JFP1 Pin Definition
Front Panel Connectors: JFP1
The mainboard provides two front panel connectors for electrical connection to the
front panel switches and LEDs. The JFP1 is compliant with Intel
® Front Panel I/O
Connectivity Design Guide.
1
2
9
10
JFP1
HDD
LED Reset
Switch
Power/
Suspend
LED Power
Switch
+
+
+ - -
-
SYSFAN1
S
E
N
S
O
R
+
1
2
V
G
N
D
+1 2V
GND
SE NS OR
CPUFAN0 AUXFAN0
SE NS OR
+1 2V
GND
PDF created with pdfFactory Pro trial version www.pdffactory.com