Revolabs HD Single & Dual Channel System — Tandberg MXP 880 User Manual
Revolabs Equipment
Revolabs HD Single / Dual Channel System — Tandberg MXP 880 Setup Guide
This setup guide will guide you through the steps needed to properly connect a
Revolabs HD Single or Dual Channel System to a Tandberg MXP 880 video codec.
Note:
It is important to carefully follow these instructions in order and completely.
Otherwise your Revolabs Microphone System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs HD Single or Dual Channel System
2. Tandberg MXP 880 video codec
3. QTY 1 3.5mm balanced male to XLR male cable*
* 07-35MBTOXLR-01 3.5mm balanced male to XLR male cable available from
Revolabs
NOTE:
IMAGES
OF
SET
UP
SCREENS
ARE
DEFAULT
SETTINGS
FROM
T
ANDBERG
AND
ARE
PART
OF
THE
T
ANDBERG
MXP A
DMINISTRATOR
’
S
G
UIDE
© M
AY
2008