Vollrath E257 - Manual (Page 17)

9
SECTION 3
INITIAL SET-UP AND OPERATION
3.1 OPERATOR'S SAFETY PRECAUTIONS
A. Know the freezer. Read and understand the Operating
Instructions.
B. Notice all warning labels on the freezer.
C. Wear proper clothing. Avoid loose fitting garments,
and remove watches, rings or jewelry which could
cause a serious accident.
D. Maintain a clean work area. Avoid accidents by
cleaning up the area and keeping it clean.
E. Stay alert at all times. Know which switch, push-
button or control you are about to use and what
effect it is going to have.
F. Disconnect electrical cord for maintenance. Never
attempt to repair or perform maintenance on the
freezer until the main electrical power has been
disconnected.
G. Do not operate under unsafe operating conditions.
Never operate the freezer if unusual or excessive
noise or vibration occurs.
3.2 OPERATING CONTROLS AND INDICATORS
Before operating the freezer, it is required that the operator
know the function of each operating control and indicator.
Refer to Figure 12 for the locations of the operating controls
and indicators.
WARNING
THE STIRRING ONLY-OFF-STIRRING & FREEZING
SWITCH MUST BE PLACED IN THE OFF POSITION
WHEN DISASSEMBLING FOR CLEANING OR SERVIC-
ING. THE FREEZER MUST BE DISCONNECTED FROM
ELECTRICAL SUPPLY BEFORE REMOVING ANY AC-
CESS PANELS. ONLY A QUALIFIED SERVICE TECH-
NICIAN MAY REMOVE ACCESS PANELS.
STIRRING ONLY-OFF-
STIRRING & FREEZING
TOGGLE SWITCH RESET
SWITCH 24-HOUR TIMER HIGH PRESSURE MANUAL
RESET SWITCH
Figure 12
Operating Controls