Vollrath E257 - Manual (Page 22)

14
Figure 21
Removing Divider Plate from Agitator Fingers
6. Remove the drive shaft by pulling straight up and
out of the vertical center post (Fig.22).
Figure 22
Removing Drive Shaft
Figure 23
Exploded View of Divider Plate and Agitator
Assembly
5. Unscrew the divider plate from the agitator fingers
and remove (Fig.21).
7. Place all loose parts in a pan or container and take
them to the wash sink, filled with warm, soapy
water, for cleaning.
CAUTION
DO NOT DAMAGE PARTS BY DROPPING OR ROUGH
HANDLING.
NOTE
Do not attempt to wash the inside of the vertical
product cylinder center post.
8. Wash the inside of the product cylinder with warm,
soapy water, using the brush provided.