Vollrath 219-02 User Manual

Page 16

Advertising
background image

8

CLEANING MIX LINES

The mix lines must be cleaned and sanitized whenever

changing mix or whenever the freezer is off for an

extended period of time – such as overnight, or nonbusiness

days. The mix lines are sufficiently cleaned and sanitized

when cleaning and sanitizing the pump and freezer as an

assembly.

Once every 2 weeks, if required, perform the following

steps:

A. Mix 2 gallons of milkstone remover solution according

to the directions on the container and pump through

the mix line.

B. Cut a piece of sponge slightly larger than the inside

diameter of the mix line. Place the sponge inside the

mix line and force through with tap water pressure. A

garden hose repair end clamped to the mix line works

well for this purpose.

3.6

DISASSEMBLY OF MIX PUMP

Refer to your Owner’s Manual for detailed instructions on

proper freezer operation.

WARNING

THE MIX PUMP SWITCH MUST BE IN THE OFF

POSITION WHEN SERVICING OR CLEANING

PUMP.

A. Drain freezer according to freezer owner’s manual.

CAUTION

NEVER DISCONNECT HOSES FROM FREEZER

OR PUMP WITHOUT FIRST OPENING SPIGOT

TO RELIEVE PRESSURE.

B. REMOTE MODEL: Loosen hose clamps and remove

tubing from pressure relief valve. Remove suction

tubing from pump and mix bag. Remove discharge

tubing from bottom of pump. Remove drive pin by

pulling straight out.

HOPPER MODEL: Remove liquid level indicator .

Remove the two wing nuts from the pressure switch

manifold retainer and remove the manifold (both

models).

C. Remove large hand nut (1), washers (2) and rear

hopper cover (3). (See Fig. 5)

Figure 5. Pump Assembly Removal

D. Remove quick connect (4) from manifold (5). Remove

two wing nuts (6), locking plate washer (7), and

manifold (5). Remove manifold connector O-ring (8)

from manifold (5), and manifold “O”-ring (9). Loosen

hose clamp (10) and remove hose (11). (See Fig.

6)

E. Remove two small hand nut(s) (12) and top lock plate

(13) from clamp rod (14). (See Fig. 7)

Figure 6. Manifold Disassembly

CYLINDER

TOP

LEVEL

INDICATOR

1

2

1

1

2

REMOTE

MODEL

SUCTION CUP

3

7

4

11

10

9

5

8

6

Advertising