Kodak DC265 - Manual (Page 129)

T
roub
leshoot
ing
10
10-11
LCD Messages
If you are experiencing difficulties and the LCD displays an error message, refer
to the following table for possible solutions.
LCD Messages
Problem Cause Solution
Memory card is Full. Memory card is full
and cannot hold
additional pictures Transfer pictures to
your computer, insert
a memory card that
has available memory,
or delete some
pictures.
No Memory Card. There is no memory
card inserted in the
camera. Insert a memory card
into the camera.
Cannot read memory card. Memory card is
corrupted. Insert a new or
reformat the memory
card.
Camera did not establish
connection. The camera cannot
communicate with the
computer. See Diagnostics on
page 10-9.
Camera needs service. The camera is
malfunctioning. Have the camera
serviced.
The receiving camera does not
have enough memory to
receive the pictures. In a camera to camera
communication, the
receiving camera
memory card is full. Transfer pictures to
your computer or
insert a memory card
that has available
memory.
Unable to receive picture. An error has occurred
while receiving
pictures in a camera to
camera transfer. Try the camera to
camera transfer again.
Transfer of pictures was
interrupted. Not all pictures
were sent. An error has occurred
before all pictures
were transferred. Try the transfer again.
Out of Range Camera is too close to
the subject. Move the camera to a
minimum of 0.3 m
(1 ft) from the subject.