Kodak ESP 3 - Manual (Page 11)

Product Overview
USB Port
You can use the USB port on the front panel of the Kodak ESP 3 All-in-One printer to connect a
PictBridge camera and print pictures directly from the camera. The Kodak ESP 3 All-in-One printer
can access images from most digital cameras.
You can also use the USB port to access pictures on a USB device, such as a thumb drive, and
transfer them to your computer.
Status Lights
The following tables provide information on the Kodak ESP 3 All-in-One printer status lights.
Control Panel
Light Status Cause Action/Solution
The printer is turned off.
Press On/Off to turn the printer on. All lights and displays
are off.
The printer does not have power
applied. Ensure that the power cord is properly
plugged into the back of the printer.
All lights flash once. The printer is initializing. None. Allow the printer to finish the
initialization process.
All lights are flashing
and the On/Off light is
flashing amber. The printer has detected an error
condition. Disconnect power for 5 seconds and
reconnect power. If the condition
persists, contact Kodak for assistance.
Check Color Ink Light
Light Status Cause Action/Solution
Check Color Ink
light is off.
Normal operation. This light should
be off when a color ink cartridge has
been properly installed and has
enough ink to print. None.
Check Color Ink
light blinks every few
seconds.
The color ink cartridge ink level is
low. Check the ink level in the Home Center
or on the printer status monitor
(Windows).
Check Color Ink
light is flashing.
The color ink cartridge needs to be
replaced. Replace the color ink cartridge.
Check Color Ink
light is flashing rapidly.
The color ink cartridge needs
attention. Ensure that the color ink cartridge is
installed properly.