Kodak ESP 3 - Manual (Page 12)

Chapter 1
On/Off Light
Light Status Cause Action/Solution
The printer is turned off. Press On/Off to turn the printer on.
The printer does not have power
applied. Ensure that the power cord is properly
plugged into the back of the printer.
On/Off light is off.
The printer needs attention. Disconnect the power for 5 seconds and
reconnect the power. If the problem
persists, contact Kodak for assistance.
The On/Off light is
steady green. The printer is properly powered up,
on, and ready. None. You may start printing, copying,
scanning, or other tasks.
The printer is busy. None. Normal operation when
performing a print, copy, scan, or other
job request.
The printer is initializing. None. Please wait and allow the printer
to complete the initialization process
(about 30 seconds). If the flashing
green persists, you may have an issue
with the printer.
Visit
www.kodak.com for additional
troubleshooting steps or contact your
local Kodak Call Center.
The printer is calibrating. None. Please wait and allow the printer
to complete the calibration process
(about 5 minutes).
The On/Off light is
flashing green.
The printer is preparing to print,
copy, or scan. None
The On/Off light is
steady amber. The printer has detected an error
condition. Disconnect power for 5 seconds and
reconnect power. If the condition
persists, check the Quantity display for
additional codes. Contact Kodak for
assistance.
Check the status monitor (Windows)
on your computer for a message.
The On/Off light is
flashing red. The printer has detected an error
condition that needs your attention. Please check for other lights and follow
the instruction for that light.
Check the status monitor (Windows)
on your computer for a message.
6 Kodak ESP 3 All-in-One