Kodak ESP 3 - Manual (Page 50)

Chapter 8
Troubleshooting
Printer Fails to Power On
Probable Cause
The power supply is not properly connected.
Corrective Action
•
Make sure the power cord is connected to the power supply and plugged into a grounded
power outlet or power strip.
•
If you are using a power strip, make sure it is turned on.
•
If you are using a switched power outlet, make sure the switch is on.
•
Make sure the power outlet is supplying power.
•
If none of the above corrects the problem, contact Kodak support.
Device not Recognized
Probable Cause
Any of the following can prevent your Kodak printer from reading a connected digital camera, USB
thumb drive, or memory card.
•
The camera is turned OFF.
•
The USB connector from the camera is not fully inserted in the port.
•
The memory card is not completely inserted.
•
The memory card is in backwards.
•
The memory card file system is corrupt.
•
Make sure camera is in “connect” mode (PTP).
•
More than one memory card inserted.
•
The USB device is not supported.
Corrective Action
•
Correct any connection problems and try again.
•
If the memory card file system is corrupt, reformat it in your camera.
•
Disconnect the unsupported device.
44 Kodak ESP 3 All-in-One