Lenovo ThinkVantage ImageUltra Builder Version 5.0 - Manual (Page 146)

2. If your repository contains folders, navigate to the folder where the driver
map resides.
3. In the right pane of the Repository window, click the Driver Maps tab. A list
of driver maps is displayed.
4. Double-click the appropriate driver map. The Driver Map window opens.
5. Expand the map tree.
6. Highlight either the root entry or the menu-item to which you want to add
the device-driver module.
7. In the Main window menu bar, click Insert and then click Device Driver....
The Add Device Drivers window opens.
8. In the left pane of the Add Device Drivers window, navigate to the folder that
contains the device-driver module you want to add.
9. In the right pane of the Add Device Driver window, click the module you
want to add. If you want to add more than one module at a time, use the
Shift key or Ctrl key in conjunction with the mouse to highlight multiple
modules.
10. Click OK.
11. Repeat steps 6 through 10 for each device-driver module you want to add.
12. When you are finished, click the Save icon in the Main window toolbar.
Replacing modules in a driver map
To replace one or more modules in a driver map, do the following:
1. Open the repository where the driver map resides.
2. If your repository contains folders, navigate to the folder where the driver
map resides.
3. In the right pane of the Repository window, click the Driver Maps tab. A list
of driver maps is displayed.
4. Double-click the appropriate driver map. The Driver Map window opens.
5. Expand the map tree.
6. In the Main window menu bar, click View. The View Modules window opens.
7. In the top view pane of the View Modules window, click the module you
want to replace. If you want to replaced more than one module at a time, use
the Shift key or Ctrl key in conjunction with the mouse to highlight multiple
modules.
8. Check the check box for the referenced item.
9. Click the Replace module icon, located in the View Modules window toolbar.
10. Select a replacement module from the Replace Module dialog, and click OK.
The modules are then replaced in those menu items which were checked.
Note: When replacing filters or utilities, the command line parameters are
copied from the original filter or utility to the replacement filter or
utility.
11. Repeat steps 6 through 10 for each device-driver module you want to replace.
12. When you are finished, click the Save icon in the Main window toolbar.
Working with driver-map settings and menu-item properties
Driver-map settings apply to the entire map. You use the driver-map settings to
add comments about the map, assign keywords to a map, or enable or disable the
network-sync function. Menu-Item properties apply to a specific menu item. You
132 ImageUltra Builder Version 5.0: User Guide