Lenovo M4350 Desktop - Manual (Page 63)

POST Error code POST Error message Description/Action
1762 Configuration change has occurred This error message is displayed when a hard disk
drive or optical drive change has been made.
Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
1820 More than one external fingerprint reader
is attached. Power off and remove all but
the reader that you set up within your main
operating system. If more than one external fingerprint reader is
connected to a computer, this error message will
be displayed to inform you to remove all of the
fingerprint keyboards except the one compatible
with the fingerprint application on your computer.
1962 No operating system found. Press any key
to repeat boot sequence. This error occurs only after the POST is completed.
Press any key to repeat boot sequence.
0162 Setup data integrity check failure Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
0167 No processor microcode update found This error message indicates that there is
no microcode update image for the current
microprocessor.
0175 System Security - Security data corrupted Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
0176 System Security - The system has been
tampered with This error message is displayed when the
computer is turned on with the cover open or
removed.
Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
0189 System Security - Can not read the
Security EEPROM This error message indicates that the Security
EEPROM may be broken or removed.
Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
0197 System Security - Unauthorized security
data change detected Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
0190 System Security - Invalid security change
requested Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
0199 System Security - Security password retry
count exceeded Press F1 to enter the Setup Utility program.
Then press F10 to save and exit the Setup Utility
program.
Chapter 6 . Symptom-to-FRU index 57