Lenovo M4350 Desktop - Manual (Page 83)

5. Disconnect the front audio and USB assembly cables from the system board. See “Locating parts on
the system board” on page 66.
Note: Make sure you note the locations of the cables when you disconnect the cables from the system
board.
6. Remove the screw that secures the front audio and USB assembly bracket to the chassis to remove
the bracket from the chassis.
Figure 14. Removing the front audio and USB assembly
7. Install the new front audio and USB assembly into the chassis and align the screw hole in the bracket
with the corresponding hole in the chassis.
8. Install the screw to secure the new front audio and USB assembly to the chassis.
9. Reconnect the front audio and USB assembly cables to the front audio connector and the front USB
connector on the system board. See “Locating parts on the system board” on page 66.
10. To complete the installation or replacement, go to “Completing the parts replacement” on page 103.
Replacing the optical drive
Attention:
Do not open your computer or attempt any repair before reading and understanding the Chapter 1 “Safety
information” on page 1.
This section provides instructions on how to install or replace the optical drive.
Note: The optical drive is only available in some models.
To replace an optical drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See “Removing the computer cover” on page 69.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 70.
Chapter 8 . Replacing FRUs 77