Lenovo IdeaCentre K330B - Manual (Page 39)

36
Hardware Replacement Guide
Replacing the mouse
To replace the mouse:
1. Remove any media (diskettes, CDs, or memory cards) from the drives, shut
down the computer, and turn off all attached devices.
2. Unplug all power cords from electrical outlets.
3. Locate the connector for the mouse. Refer to “Locating connectors on the
front of the computer” and “Locating connectors on the rear of the computer”.
Note: Your mouse may be connected to the standard mouse connector at
the rear of the computer or to a USB connector at either the front or rear
of the computer.
4. Disconnect the defective mouse cable from the computer.
5. Connect the new mouse cable to the connector.
6. Refer to the “Completing the installation”.
31048526 IC K3 HRG V5.0 (EN)(R).indd 36 2011-3-14 17:34:18