Replacing the external speaker, Completing the installation – Lenovo IdeaCentre K220 User Manual

Page 58

Advertising
background image

Chapter 7. Replacing hardware

55

4. Disconnect the failing mouse cable from the computer.
5. Connect the new mouse cable to the connector.
6. Refer to the “Completing the installation.”

Replacing the External speaker

1. Remove any media (diskettes, CDs, or tapes) from the drives, shut down

the computer, and turn off all attached devices.

2. Unplug all power cords from electrical outlets.
3. Locate the Speaker. Refer to “Locating connectors on the rear of the

computer” and “Locating connectors on the front of the computer”.
Your speaker might be connected to the Audio connector to an
Audio connector at either the front or rear of the computer. Locate the
connector for the speaker.

4. Disconnect the failing speaker cable from the computer and connect

the new speaker cable to the same connector.

5. Refer to the “Completing the parts replacement”.

Completing the installation

After replacing the parts, you need to close the computer cover and
reconnect cables, including telephone lines and power cords. Also,
depending on the part that was replaced, you might need to confirm the
updated information in the Setup Utility program. Refer to “Starting the
Setup Utility” in the User Guide or in the Hardware Maintenance Manual.

Advertising
This manual is related to the following products: