Lenovo ThinkStation P300 User Manual
Page 101
8. Install a new solid-state drive into the storage converter. Then install the four screws to secure the
new solid-state drive to the storage converter.
Figure 34. Installing the new solid-state drive into the storage converter
9. To install the storage converter into the 3.5-inch hard disk drive bracket, flex the bracket and align pin
1
,
pin
2
, pin
3
, and pin
4
on the bracket with the corresponding holes in the storage converter.
Figure 35. Installing the storage converter with the new solid-state drive into the hard disk drive bracket
10. Install the storage converter with the bracket into the hard-disk-drive bay. See “Replacing the primary
hard disk drive” on page 93 or “Replacing the secondary hard disk drive” on page 95.
11. Connect the signal cable and the power cable to the solid-state drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
Installing or replacing hardware
89