Lenovo ThinkStation P300 - Manual (Page 105)

10. Install the two screws to secure the mSATA solid-state drive to the storage converter.
Figure 43. Installing the screws to secure the mSATA solid-state drive
11. Slide the storage converter with the new mSATA solid-state drive into the mSATA solid-state drive bay
until it snaps into position. Then install the screw to secure the storage converter to the chassis.
Figure 44. Installing the mSATA solid-state drive
12. Connect the signal cable and the power cable to the new mSATA solid-state drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 111.
Replacing the primary hard disk drive
Attention: Do not open your computer or attempt any repair before reading and understanding the “Read
this first: Important safety information” on page v.
To replace the primary hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 71.
3. Locate the primary hard disk drive. See “Locating components” on page 5.
4. Disconnect the signal cable and the power cable from the hard disk drive.
Chapter 9 . Installing or replacing hardware 93