Lenovo ThinkStation P300 - Manual (Page 98)

10. Connect the heat sink and fan assembly cable to the microprocessor fan connector on the system
board. See “Locating parts on the system board” on page 6.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 111.
Installing or replacing the solid-state drive
The solid-state drive is only available on some models. This section provides the following instructions:
• “Installing the solid-state drive” on page 86
• “Replacing the solid-state drive” on page 87
Installing the solid-state drive
Attention: Do not open your computer or attempt any repair before reading and understanding the “Read
this first: Important safety information” on page v.
To install the solid-state drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Install the solid-state drive into the storage converter shipped with the solid-state drive. Then install the
four screws to secure the solid-state drive to the storage converter.
Figure 30. Installing the solid-state drive into the storage converter
86 ThinkStation P300 User Guide